top of page
Pruning Storm Damaged Trees
For the trees that have been affected and damaged by ice or snow buildup, careful considerations must be given to the job of repairing them and making them healthy again. Before broken branches are removed, they should be examined carefully, and proper pruning methods should be used to minimize the damage from the pruning cuts. Trees too large to handle from the ground should be pruned only by professional arborists.
Branches to Remove
Safety is the first consideration in removing branches from storm-damaged trees. All branches that are loose should be removed as soon as possible to eliminate the chance of injury or damage if they were to fall. Other branches that are cracked or broken should be removed after the loose branches are gone. Branches that did not break under the weight of the snow but were bent over may have internal cracks or other hidden damage, especially if these branches have not returned to their original upright positions. These branches may become hazards in the future and should be considered for removal. A branch (or trunk) that was partially stripped of its bark when an attached branch pulled away should be removed if more than a third of the original circumference is lost. These branches will always be structurally weak and may become serious hazards if they are allowed to remain and get larger.
Making Pruning Cuts
Pruning cuts should be made so that only branch wood is removed and the trunk or supporting stem is not injured. If only branch wood is removed, the wound is smaller, the tree will be able to seal the wound more effectively, and the chance of problems with wood decay will be greatly reduced.
To locate the proper place to make a pruning cut, look for the "branch bark ridge" on the upper surface of the union of the branch with the supporting stem. This is a line of bark that has been pushed up as the branch and supporting stem have grown. Some branch unions will not have this if they did not form properly. Instead they will have the branch simply pressing into the supporting stem, forming a sharp V-shaped union. At the base of the branch, and mostly on the underneath side, look also for the "branch collar," which is a slightly swollen area of stem tissue that wraps around the base of the branch. A proper pruning cut begins just outside the branch bark ridge and angles down and slightly away from the stem, avoiding injury to the branch collar. Do not make flush cuts that remove the branch collar. Wounds created by flush cuts cause substantially more injury to the tree than wounds left by proper pruning. Branches should be pruned using a series of three cuts as shown in the figure: two to remove the weight of the branch (first under then over the branch), then the final pruning cut.
Branches that have pulled away from the trunk should be removed at the bottom of the split. Avoid causing any additional damage to the trunk. Remove any loose bark, but do not cut into bark that is living and still attached.
When to Prune
The only pruning that should be done at this time is the removal of broken branches. Leave the fine pruning and finishing cuts until late winter or early spring. All pruning cuts will dry out to some degree during the winter. Dieback of the inner bark around a pruning cut can be minimized if the final pruning is left until just before the tree begins to grow in the spring.
Never top trees. Topping creates serious hazards and dramatically shortens the life of a tree. Never use paint or wound dressing to cover wounds. These materials do not help the tree and actually interfere with the tree's wound sealing process.
bottom of page